Sales:
+44 (0) 1226 340 888
General/Technical:
+44 (0) 1226 340 222
Email:
sales@flexseal.co.uk
Flexseal manufacture various ancillaries including the puddle flange, insitu-seal, gully seal, wall seal and tools.
|
|
|
|

Puddle Flanges ensure a watertight seal where pipes pass through the walls of tanks and swimming pools etc. They can also be used where they pass through the walls of basements, manholes or other structures below groundwater level.
Puddle Flanges are manufactured from EPDM material that provides chemical resistance to a variety of acids and alkalis, providing an effective seal against water penetration along the pipe.
Flexseal can provide a range of puddle flanges that are preformed or fabricated to meet specific site requirements.
Insitu-seals are used to connect to a 90-degree lateral pipe into a twin wall or ribbed surface water drainage pipe.
| Insitu-Seal 110mm | Insitu-Seal 160mm | |
| Minimum OD of main pipe | 200mm | 300mm |
| Lateral pipe |
110mm OD Land Drain | 160mm OD Land Drain |
| Drilled hole size | 127mm | 177mm |
Note: special 90mm deep hole saws are required.
Gully seals are fitted into 200mm and 210mm sockets of all monolithic concrete road gullies, and suitable for use on the following pipes:
Wall seals are used to seal around a cored hole passing through a pre-cast structure. The wall seals can also:
Moulded wall seals are available to suit most common pipe sizes and materials from 35mm to 200mm OD, and Flexseal also supply fabricated wall seals for larger pipe sizes.
Flexseal have a full range of drilling equipment available, including: